Channel 2 LED lighting red after starting scope
Join the Cleverscope user forum — ask questions,
share setups and get help from the community and team.
Channel 2 LED lighting red after starting scope, a forum discussion on Cleverscope Mixed Signal USB Oscilloscopes. Join us for more discussions on Channel 2 LED lighting red after starting scope on our Questions forum.
You must be logged in to post a reply
 Back to Forum Index : Back to Questions |
 |
Booster
Yesterday, 02:42am
Posts: 5
Hey,
We are experiencing two issues with our Cleverscope CS548 after a recent firmware update, and we would appreciate your help.
1. Channel 2 LED lights sometimes red
After turning on the CS548, the device cycles through all colors. After this procedure Channel 2 sometimes stays solid red.
- This happens even if we swap the cables or disconnect the external device entirely.
- After power-cycling the Cleverscope multiple times (about 10 times), the LED finally turns green.
- This issue existed before, but it became significantly worse after updating the firmware to Version 05.05.34.
2. Channel 1 Blue LED (we don’t know, if it was a failure)
When we configure the Cleverscope via a Python script and select a trigger channel, the LED on Channel 1 turns blue.
-We initially thought the blue LED indicates the selected trigger channel. However, even if we set Channel 2 or Channel 3 as the trigger channel, Channel 1 remains blue.
-After the measurement finishes, Channel 1 switches back to green.
-This behavior only started appearing after the latest firmware update.
Device & Software Details:
Device: Cleverscope CS548 Hw-Version 5.1 (Sn: EW10200)
Probes: Channel1:HP-9258 ; Channel2:CP-2250
Previous Firmware Version (where red LED was less frequent): As supplied in 2022/2023
Current Firmware Version: 05.05.34
What could be the root cause of the Channel 2 boot issue? Is it a hardware tolerance/drift problem? And what could be the reason for the blue lighting LED?
Thanks in advance for your reply!
Best regards
We are experiencing two issues with our Cleverscope CS548 after a recent firmware update, and we would appreciate your help.
1. Channel 2 LED lights sometimes red
After turning on the CS548, the device cycles through all colors. After this procedure Channel 2 sometimes stays solid red.
- This happens even if we swap the cables or disconnect the external device entirely.
- After power-cycling the Cleverscope multiple times (about 10 times), the LED finally turns green.
- This issue existed before, but it became significantly worse after updating the firmware to Version 05.05.34.
2. Channel 1 Blue LED (we don’t know, if it was a failure)
When we configure the Cleverscope via a Python script and select a trigger channel, the LED on Channel 1 turns blue.
-We initially thought the blue LED indicates the selected trigger channel. However, even if we set Channel 2 or Channel 3 as the trigger channel, Channel 1 remains blue.
-After the measurement finishes, Channel 1 switches back to green.
-This behavior only started appearing after the latest firmware update.
Device & Software Details:
Device: Cleverscope CS548 Hw-Version 5.1 (Sn: EW10200)
Probes: Channel1:HP-9258 ; Channel2:CP-2250
Previous Firmware Version (where red LED was less frequent): As supplied in 2022/2023
Current Firmware Version: 05.05.34
What could be the root cause of the Channel 2 boot issue? Is it a hardware tolerance/drift problem? And what could be the reason for the blue lighting LED?
Thanks in advance for your reply!
Best regards
| Back to Forum Index : Back to Questions |
|